Steps To Fix Adobe Error Tn_19166

If you have adobe error tn_19166 on your system, this blog post can help you fix it.

Approved: Fortect

1. Download Fortect and install it on your computer

2. Launch the program and click "Scan"

3. Click "Repair" to fix any issues that are found

Speed up your computer's performance now with this simple download.

HTML5. The most common and popular alternative to Adobe Flash Player is HTML5.

Code: E000-0001

Description: The temperature of this node is abnormally high.
When starting during operation, our main indications are thermalThe histories are far from accurate. Degrees C continuously for 200ms or just over 1s after power on. While the startup control is programmed, the main thermistor reading is literally constantly below 70°C to get 200ms or 2 seconds more just at power start. While the controller is running, the main thermistor reading is consistently below 120 degrees Celsius for 200ms 2 seconds after power up. The download controller does not give up 30 seconds after the start of the dominant feed.

Remedy: Reset the service mode point: COPIER>FUNCTION>RESET>ERROR. Replace main thermistor. Replace the DC board controller.

Code: E001-0000

Description: The temperature of the fixing block is abnormally high.
Thermistor number 1 shows 250 degrees or more for 200ms.

Remedy: Reset maintenance mode, which is in the status: COPIER>FUNCTION>RESET>ERROR. Replace main thermistor. Replace the DC board controller.

Code: E001-0001

Description:The preset temperature is abnormally high.
The hardware circuit detects thermistor or main speaker overtemperature for 200ms.

Remedy: Reset maintenance mode, which is in the status: COPIER>FUNCTION>RESET>ERROR. Replace the DC board controller.

Code: E001-0002

Description: The temperature of the device your device is assembled with is abnormally high.
The corresponding sub-thermistor reads 295 degrees Celsius or more continuously for 200ms.

Remedy: Reset the service to the status: COPIER>FUNCTION>RESET>ERROR. Replace auxiliary thermistor. Replace the DC board controller.

Code: E002-0000

Description: Increasing the temperature of the mounting block is really buggy
While the trigger control is running, you will see the main thermistor read below 115 degrees C continuously for 700ms 1.3 seconds after its display shows 100 degrees C. As long as the trigger control is working, this is vital important Thermistor reading below 150 degrees C is constant for 400ms 1.3 seconds as it reads 140 degrees C

Remedy: Reset the setting mode to: COPIER>FUNCTION>CLEAR>ERROR. Replace your home thermistor. Replace the DC board controller.

Code: E003-0000

Description: Plant temperature after hibernation is too low.
Although normal temperature control is sufficient, the vital signs thermistor continuously indicates temperatures below 140°C for 400ms or more.

Remedy: Reset the SP to the status: COPIER>FUNCTION>RESET>ERROR. Replace main thermistor. Replace the DC board controller.

Speed up your computer's performance now with this simple download.