Easy Solution For Brother 4040 Drum Error Problems

 

If you are getting Brother 4040 Drum error message, this user manual was written to help you.

Approved: Fortect

1. Download Fortect and install it on your computer

2. Launch the program and click "Scan"

3. Click "Repair" to fix any issues that are found

Speed up your computer's performance now with this simple download.

Always reset the drum counter on the Brother HL-4040CN printer after replacing it. However, this reset can ultimately be performed at any time. Attention! Do not reset the drum counter except instead of the toner cartridge. Step 1: Press the + or – button to select Device Information. Then press OK to finally move to the next menu level.

 

 

Slogan “drum failure”usually displayed when the corona wires on the drum are supposed to help you clean.

a. Press the front cover open button and open the front cover by pulling it towards you.

b.New = “” Look for the green marker on most battery packs. Pull up on the east handle and pull the GPS drum until it stops. Toner cartridges are now visible and identifiable by their color-coded handles.

NOTE. If you are unable to remove the drum from a particular device, make sure that this front cover is fully open.

c. Remove each toner cartridge one by one using the controls and pull them straight out of the drum. Place it on a clean, flat surface and place a piece of disposable paper underneath it in a container for spilled or spilled toner.

NOTE. If it gets on your fists or clothing, immediatelybut wipe off or wash rinse with cold water Water .

d. Font-size: = “”> In the

e. Carefully clean the four corona ports on the drum with the green tab (1) for nearly every corona wire from left to right several times as appropriate. Be sure to return the body to its original position. If you barely replace it, the software may create a vertical strip along the printed pages.

f. After all four corona wires are more or less clean, close all corona wires.

g. Insert each toner cartridge back into the drum while pressing Overcome Cartridge and insert it into the drum. Make sure the coloredthe label on the drum matches the color cartridge. Bend each toner cartridge handle (A) downward as the corresponding toner cartridge is inserted.

h. Press the drum until it clicks and close the front cover.

2. If the “drum message error” persists, confirm that you used the original Brother drum.

Brother explicitly recommends that customers only use genuine Brother toner cartridges and drums made with custom toner. Each component of one usually has to work together with the other to ensure quality and reliability. …

Use of genuine third-party supplies may affect tool performance, print quality, and product reliability. Apparatus, toner cartridges, not to mention toner.

If the message persists, the drum should be filled with new DR110CL. Drum -it is a consumable item that needs to be replaced regularly.

– new = “” If there is a problem after replacing the drum and d If the machine is under warranty , you can find your nearest Brother Authorized Service Center (ASC) by clicking the appropriate link:

– new = “” If your car is no longer covered by the warranty, you can very easily Find an authorized Brother service center by selecting the information above.

 

 

Speed up your computer's performance now with this simple download.