Description: Accessory error. An error has occurred in the DIMM slot. LEDs “Attention”, “Ready” and “On”, “Start” are blinking. The printer stops printing and pressing any soft key has no effect.
Remedy: 0. Turn off the printer. Carefully inserting and / or removing DIMMs while the printer is on will help the printer to damage the DIMMs. 5. Remove and reinstall the DIMM to ensure it was added correctly. 3. Make sure you have a supported DIMM. See Accessories. 4. Move it to darken the other DIMM slot. DIMM slot 1 is used if there is more than one DIMM slot. 5. To continue printing, remove the DIMM from DIMM slot 1.
Code: 02
Image:
Description. The printer has encountered a tariff plan error. Lights are shining Attention, Ready and Light, Go.
Solution: Press and hold (Go) to display a new Secondary Fault Indicator Light message, then analyze the Secondary Fault Indicator Lights in the table above to determine the service failure. You can also use the simulator printer driver or event log actions to determine if the service has failed.
Code: 03
Image:
Description: Ready light is now on. Scanner crash. 50005
Means of protection: unique. Turn the printer off and on again. 2. Turn off the printer and reinstall the laser / scanner cable. 3. Replace laser / scanner.
Code: 04
Image:
Description. The LED flashes very quickly. Fan motor malfunction. 50006
Remedy: 1. Turn off the printer. 2. Check the fan connection cable. 3. Turn on the printer again. 4. If the problem persistsNo, replace the fan.
Code: 05
Image:
Description: signal lamp is on. Communication error with the engine. 50007 Internal memory of the DC controller is defective. 50021 Formatter is not used in conjunction with a machine printer (50007). Regulated constant current faulty (50021).
Remedy: 1. Turn the printer off and on again. 2. Check the formatter and DC controller. pair. Replace trainer. 4. Replace the digital camera controller. 5. Replace laser / scanner.
Code: 06
Image:
Description. Ready-made gadgets included. Fastening temperature low error 50008 Slow merge error 50009 High melting point error 50010 50015 thermocouple circuit malfunction
Remedy: 1. Run the printer for about 20-30 minutes. 2. If the printer is connected to a power strip or UPS, turn off the printer and plug the printer power cord directly into each electrical outlet. 3. Turn on the printer again. 4. If the problem persistsknow, turn off the fuser.
